– Production Ready (PR) Booklet Maker Finisher (for Bi-Fold or Single-Fold)
– Optional C/Z Folder with one of the following optional finishers:
– PR Finisher
– PR Booklet Maker Finisher
– PR Finisher Plus
• For detailed information about these finishing devices, refer to the C/Z Folder.
• Create or use an existing Finisher - Fold Adjust Position
Note: Before you create a new or use an existing profile or performing any alignment adjustments, read
or review the Fold Adjustment Profile section in the System Administrator Guide.
• Depending on your system configuration, the following fold adjustments are available:
– Bi-Fold Single Sheet (available only with the PR Booklet Maker Finisher)
– Bi-Fold Multiple Sheets (available only with the PR Booklet Maker Finisher)
– Bi-Fold Multiple Sheets Stapled (available only with the PR Booklet Maker Finisher)
– C-Fold (available with the optional C/Z Folder)
– Z-Fold (available with the optional C/Z Folder)
– Z-Fold Half-Sheet (available with the optional C/Z Folder)
• Create a new or use an existing Finisher - Fold Adjust Position. The following steps are required for creating a
new or using an existing procedure.
Note: This option is accessed from Machine Status > Tools > Setup & Adjustment > Finisher - Fold
Adjust Position.
1. From the Fold Adjustment tab, select the New or Edit button.
If you edit an existing fold adjustment, select Machine Status > Tools > Setup & Adjustment > Custom
Paper Settings. Select the desired Custom Paper > Change Settings > Adjust Fold Position > Change
Settings.
2. Type in a new name or, if desired, edit the existing name.
3. To complete the procedure, refer to the Fold Adjustment Profile section in the System Administrator Guide.
SMEAR AT 208 MM FROM THE LEAD EDGE
PPrroobblleemm
On the printed output, a smear occurs at 208 mm from the lead edge of the paper.
304
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting
To Next Page
Loading...
