Xerox Versant 280 - Troubleshooting Multifeeds in the HCVF

When using paper of weights less than 177 g/m² and printing five or fewer sheets, misfeed problems can
occur.
Make the following adjustments:
1. Change the Custom Table setting to 32. Save the setting.
2. Run a test print. If no misfeed occurs, the problem is resolved.
3. If a misfeed occurs again, change the Custom Table setting to 33. Save the setting.
4. Run another test print. If the problem is not resolved, contact your Xerox representative.
Misfeeds when using paper weight less than 177 g/m² and printing more than five sheets
When using paper of weights less than 177 g/m² and printing more than five sheets, misfeed problems
can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 5. Save the setting.
b. Run a test print. If no misfeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no misfeed occurs, the problem is resolved.
e. If misfeeds continue, repeat steps 1c and 1d until the Custom Table setting reaches 8.
2. If a misfeed occurs again, change the Custom Table setting to 32. Save the setting.
3. Run a test print. If no misfeed occurs, the problem is resolved.
4. If a misfeed occurs again, change the Custom Table setting to 33. Save the setting.
5. Run another test print. If the problem is not resolved, contact your Xerox representative.
Troubleshooting Multifeeds in the HCVF
When using the optional High Capacity XLS Vacuum Feeder (HCVF), the following fault codes indicate a multifeed
condtion:
• 077–131, 077–132.
• 078–125, 078–126, 078–127.
For fault codes relating to misfeeds, refer to Troubleshooting Misfeeds in the HCVF.
To resolve a multifeed, follow the steps in the appropriate section.
Multifeeds when using coated paper weight 177 g/m² or heavier
Xerox
®
Versant
®
280 Press User Documentation 343
Troubleshooting