Xerox Versant 280 - Page 344

Humidity levels of 50 percent or higher
When using coated paper of weight 177 g/m² or heavier in humidity levels of 50 percent or
higher, multifeed problems can occur.
Make the following adjustments:
1. If the paper is coated on one side only, go to step 3.
2. If the paper is coated on both sides, do the following:
a. Change the Custom Table setting to 5. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 2c and 2d until the Custom Table value reaches 8.
3. If using paper that is coated on one side only, or if multifeeds continue, do the following:
a. Change the Custom Table setting to 9. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 3c and 3d until the Custom Table value reaches 12.
4. If the problem is not resolved, contact your Xerox representative.
344
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting