Humidity levels below 50 percent
When using coated paper of weight 177 g/m² or heavier in humidity levels below 50 percent,
multifeed problems can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 9. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 1c and 1d until the Custom Table value reaches 12.
2. If multifeeds continue, do the following
a. Change the Custom Table setting to 35. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 2c and 2d until the Custom Table value reaches 38.
3. If the problem is not resolved, contact your Xerox representative.
Xerox
®
Versant
®
280 Press User Documentation 345
Troubleshooting
To Next Page
Loading...
