Multifeeds when using uncoated paper weight 177 g/m² or heavier
When using uncoated paper of weight 177 g/m² or heavier, multifeed problems can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 9. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 1c and 1d until the Custom Table setting reaches 12.
2. If the problem is not resolved, contact your Xerox representative.
346
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting
To Next Page
Loading...
