Xerox Versant 280 - Page 347

Multifeeds when using paper weight less than 177 g/m²
Humidity levels of 50 percent or higher
When using paper of weight less than 177 g/m² in humidity levels of 50 percent or higher,
multifeed problems can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 9. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 1c and 1d until the Custom Table value reaches 12.
2. If multifeeds continue, do the following:
a. Change the Custom Table setting to 5. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 2c and 2d until the Custom Table value reaches 8.
3. If a multifeed occurs again, change the Custom Table setting to 32. Save the setting.
4. Run a test print. If no multifeed occurs, the problem is resolved.
5. If a multifeed occurs again, change the Custom Table setting to 33. Save the setting.
6. Run another test print. If the problem is not resolved, contact your Xerox representative.
Xerox
®
Versant
®
280 Press User Documentation 347
Troubleshooting