Xerox Versant 280 - Page 348

Humidity levels below 50 percent
When using paper of weight less than 177 g/m² in humidity levels below 50 percent, multifeed
problems can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 5.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 1c and 1d until the Custom Table value reaches 8.
2. If a multifeed occurs again, change the Custom Table setting to 32. Save the setting.
3. Run a test print. If no multifeed occurs, the problem is resolved.
4. If a multifeed occurs again, change the Custom Table setting to 33. Save the setting.
5. Run a test print. If no multifeed occurs, the problem is resolved.
6. If multifeeds continue, do the following:
a. Change the Custom Table setting to 9. Save the setting.
b. Run a test print. If no multifeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no multifeed occurs, the problem is resolved.
e. If multifeeds continue, repeat steps 6c and 6d until the Custom Table value reaches 12.
7. If the problem is not resolved, contact your Xerox representative.
348
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting