5. Select Change Settings.
6. At the Settings window, select Adjust Air Assist Values > Change Settings.
7. At the Adjust Air-Assist Values window, select Custom Table.
Note: The Custom Table contains a set of numerical settings. Each numerical value in the Custom Table
maps to a specific blower configuration in the HCVF.
8. To change the Custom Table setting, type the required number. Alternatively, use the up and down arrows to
select the number.
9. To save the Custom Table setting, select Save.
10. To save the profile, select Save.
11. To close the Custom Paper Settings window, select Close.
12. To close the Paper Tray Settings window, select Close.
Troubleshooting Misfeeds in the HCVF
When using the optional High Capacity XLS Vacuum Feeder (HCVF), the following fault codes indicate a misfeed
condition:
• 078–101, 078–131, 078–132, 078–151
• 178–101, 178–131, 178–132, 178–151
For fault codes relating to multifeeds, refer to Troubleshooting Multifeeds in the HCVF.
To resolve a misfeed, follow the steps in the appropriate section.
Misfeeds when using paper weight 177 g/m² or heavier
When using paper of weights 177 g/m² or heavier, misfeed problems can occur.
1. Make the following adjustments:
a. Change the Custom Table setting to 5. Save the setting.
b. Run a test print. If no misfeed occurs, the problem is resolved.
c. Increase the Custom Table value by one setting. Save the setting.
d. Run a test print. If no misfeed occurs, the problem is resolved.
e. If misfeeds continue, repeat steps 1c and 1d until the Custom Table setting reaches 8.
2. If the problem is not resolved, contact your Xerox representative.
Misfeeds when using paper weight less than 177 g/m² and printing five or fewer sheets
342
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting