d. Use the cleaning rod to sweep any remaining waste or debris from inside the trimmer into the trimmer
waste container.
e. If you have difficulty sweeping waste into the trimmer waste container, use the cleaning rod to gather
waste, then remove the waste by hand.
f. Return levers 3a and 3d to their original positions.
6. To ensure that all waste and debris is removed, especially beneath the frame that is located behind the
container, use the cleaning rod to remove any remaining waste from inside the trimmer.
For information, refer to Emptying the Crease and Two-Sided Trimmer Waste Container.
7. Close the trimmer upper and lower covers.
8. If the press indicates there are additional paper jams, follow the instructions to clear the paper and to resume
printing.
Crease and Two-Sided Trimmer Fault Messages
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops printing and
a message appears on the press touch screen. A graphical illustration shows the location of the fault with a brief
explanation of corrective actions for clearing the fault. If a fault occurs in more than one location, the illustration
changes to indicate the multiple locations and the required corrective actions.
The touch screen also displays a Faults button which provides information about the fault and detailed instructions
for correcting the fault. The (EE) code on the upper-left part of the Fault message displays which error indicator is lit
on the Crease and Two-Sided Trimmer indicator panel (E1–E7).
Xerox
®
Versant
®
280 Press User Documentation 387
Troubleshooting
To Next Page
Loading...
