SSoolluuttiioonnss
• Ensure that the media used is approved, within press specifications and is clean.
• Check that the press is within environmental specifications and humidity levels.
• Load a new ream of paper or different type of media.
• Run the Clean Toner procedure. For instructions, refer to the the System Administrator Guide, Maintenance >
Common Service Settings.
• Check for Drum failure or damage. Acquire your measuring tool from either www.xerox.com/VERSANT_280docs
or the Nationalization Kit.
– Check the frequency of the spot intervals. If spots occur every 147 mm on the prints, determine which color
drum is affected.
– To determine which color drum is affected, go to www.xerox.com/VERSANT_280docs, to download, and
then print the Halftone Test Pattern PDF.
• To replace or swap the drum; refer to Drum Cartridge.
REPEATING DEFECTS AT REGULAR INTERVALS ON PRINTS
PPrroobblleemm
The prints show any defect type that repeats at intervals that can be measured.
Xerox
®
Versant
®
280 Press User Documentation 287
Troubleshooting
To Next Page
Loading...
