DUAL ADVANCED OVERSIZED HIGH CAPACITY FEEDER, TRAYS 8 AND 9
Trays 8 and 9 Overview
Important: The Dual Advanced Oversized High Capacity Feeder (OHCF), Trays 8 and 9, can be added only to
a system which includes Trays 6 and 7.
Trays 8 and 9 can be added to the system to extend the paper capacities by providing two additional trays. Trays 8
and 9 feed a variety of stock sizes, including standard, heavyweight, and oversized stocks up to 330 x 488 mm (13 x
19.2 in.) in size and weighing between 52 g/m
2
and 400 g/m
2
. Each tray holds 2000 sheets of coated and
uncoated stock.
Note: The OHCF comes equipped from manufacturing with the Postcard bracket tray inserter.
If using the optional Postcard bracket, minimum size is 101.6 x 152.4 mm (4 x 6 in.)
Note: For more information on the optional Postcard Bracket, refer to Paper and Media.
Paper and Media for Trays 8 and 9
Loading Paper in Trays 8 and 9
1. Select the appropriate paper stock for your print/copy job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load paper into the tray.
6. Adjust the paper guides by pressing in the guide release and carefully moving the Edge Guide until it lightly
touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
140
Xerox
®
Versant
®
280 Press User Documentation
Working With
To Next Page
Loading...
