5. Remove and replace the separator roll using the same technique.
6. Close the bypass tray cover.
7. Verify that the tray is operating correctly by feeding paper from the bypass tray.
8. Log in as the administrator or ask the administrator to perform the following steps to reset the HFSI count to
zero (0):
a. At the UI press the Machine Status button.
b. Select the Tools tab.
c. Select System Settings > Common Service Settings > Maintenance.
d. Use the arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator (TKO) icon.
The Technical Key Operator feature displays.
f. Log in to the Technical Key Operator mode.
AAtttteennttiioonn
If you cannot log in as TKO, or do not have the TKO password, call your Customer Service Engineer.
g. Select the bypass rolls item that corresponds with the newly-replaced components.
h. Select Reset Current Value. The system resets the HFSI to 0.
9. Exit the administrator mode by pressing the Log In/Out button on the UI.
When prompted, select Logout.
Replacing Trays 6 and 7 Feed Rolls
Replace the feed rolls every 300,000 prints or when experiencing frequent multifeeds, single feeds, or blank prints in
the stack of the output prints.
Use this procedure to replace the feed rolls, which includes:
• Feed Roll
• Nudger Roll
Xerox
®
Versant
®
280 Press User Documentation 245
Working With
To Next Page
Loading...
