• The electrical supply for the press must meet the requirements stated on the data plate located on the rear of
the press. If necessary, consult your local electricity provider or a licensed electrician.
• Do not place the press in an area where people can step on the power cable.
• Do not place objects on the power cable.
• Do not plug or unplug the power cable while the power switch is in the On position.
• If the power cable becomes frayed or worn, replace it.
• To avoid electrical shock and damage to the cable, grasp the plug when unplugging the power cable.
Disconnect Device
The power cable is the disconnect device for this equipment. To remove all electrical power from the machine,
disconnect the power cable from the electrical outlet.
LASER SAFETY
North America Laser Safety
This product complies with safety standards and is certified as a Class 1 Laser product under the Center for Devices
and Radiological Health (CDRH) of the United States Food and Drug Administration (FDA) implemented regulations
for laser products. This product complies with FDA performance standards for Laser products except for deviations
pursuant to Laser Notice No. 50 dated June 24, 2007. These regulations apply to laser products marketed in the
United States. The label on the Production Press indicates compliance with CDRH regulations and must be attached
to laser products marketed in the United States. This product does not emit hazardous laser radiation.
Laser Warning: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous exposure of laser light.
Since radiation emitted inside this product is completely confined within the protective housing and external covers,
the laser beam cannot escape from the Production Press during any phase of the user operation.
This product contains laser warning labels. These labels are intended for use by the Xerox Service Representative
and are placed on or near panels or shields that require special tools for removal. Do not remove any of the panels.
There are no operator serviceable areas in these covers.
European Union (EU) Laser Safety
This product complies with IEC safety standard EN 60825-1: 2014.
The equipment complies with laser product performance standards set by governmental, national, and international
agencies as a Class 1 Laser Product. It does not emit hazardous radiation as the beam is totally enclosed during all
phases of customer operation and maintenance.
Warning: Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
If you need additional safety information about the product or Xerox supplied materials, you can email request to
EHS-Europe@xerox.com.
Xerox
®
Versant
®
280 Press User Documentation 13
Learning About
To Next Page
Loading...
Need help?
General
