Purge Function for Tray T1
If tray T1 runs out of paper, the press stops printing. When this happens, any printed output leaving the press is
delivered to the inline finishing device output tray.
Tip: Do not reuse the output that is ejected by the purge function as this may cause paper jams.
To prevent the purge function from occurring when tray T1 runs out of paper, the function may be disabled or
switched off from the press Tools mode.
Important: Only a system administrator for the press can change the setting for the purge function for tray
T1.
Tray T1 Purge Function Settings
The purge function allows you to specify how the press behaves when tray T1 is used. The purge function has two
settings:
SSttaannddaarrdd
For each printed set that requires the inclusion of paper into the finished set, the press checks that paper Is
loaded in tray T1 before it starts printing.
This setting increases the wait time between sets, which causes decreased productivity. However, paper purging
does not occur even if tray T1 runs out of paper.
SSppeeeedd FFiirrsstt
The printer starts printing regardless of the paper status of tray T1.
This setting maintains productivity based on press productivity. However, paper is purged from the press and
the press stops printing when tray T1 runs out of paper.
Note: Speed First is the default setting for the tray T1 purge function.
Changing the Purge Function Setting for Tray T1
Important: The following procedure must be performed by a system administrator with press administrator
login authority.
1. Log in as the administrator.
2. On the control panel, press the Machine Status button.
3. Touch the Tools tab.
4. Select System Settings > Common Service Settings.
Xerox
®
Versant
®
280 Press User Documentation 185
Working With
To Next Page
Loading...
