Cleaning the Document Feeder Rollers
1. Gently lift the latch of the document feeder top cover until it is open completely in a fixed position.
2. While turning the rollers, gently clean them with a soft cloth moistened with water.
Caution: Use a cloth that has been thoroughly wrung to prevent drops of water falling into the press.
Drops of water on internal components may cause a malfunction.
If dirt is difficult to remove, try gently wiping with a soft cloth moistened with a small amount of neutral
detergent.
3. Close the top cover of the document feeder until you hear it click into place.
4. Close the left cover of the document feeder until you hear it click into place.
Cleaning the Drum Drawer Area
When you are replacing a drum cartridge, before inserting the new cartridge, perform these steps to clean under
the drum cartridge area:
1. With the Drum Cartridge Drawer open, look for dry ink/toner waste on the bottom of the catch pan under the
drum cartridges.
2. Use a clean cloth to wipe down the catch pan.
3. Continue following the instructions on how to insert the new cartridge.
Cleaning the ROS Windows
Unfused dry ink/toner collects on the 4 color ROS window areas located just above the Drum Cartridge Drawer
within the press. Contaminated ROS windows can cause a white streak defect on your printed output.
Perform this procedure to clean the ROS window of the affected color whenever:
• You replace the drum cartridge
• A white streak (no image captured) shows in the same position on every print
232
Xerox
®
Versant
®
280 Press User Documentation
Working With
To Next Page
Loading...
