Xerox Versant 280 User Manual

SSoolluuttiioonnss
1. Confirm that the media being used is compatible with the press, is within supported specifications, and is in
good condition.
2. Change the Adjust Paper Speed at Transfer Module setting.
• Use this feature to adjust the paper speed in the transfer unit.
• The option can be found in Machine Status > Tools > Setup & Adjustment > Custom Paper Settings.
Select the desired Custom Paper > Change Settings > Adjust Paper Speed at Transfer Module >
Change Settings.
• Based on the output, decrease Adjust Paper Speed at Transfer Module in increments of 0.05%. After
every increment adjustment run test prints and evaluate the output to determine if additional adjustment is
necessary.
• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the Adjust Fusing Speed setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge (LE). Increase the
fuser speed to correct the issue.
• This feature also impacts print quality.
– Increasing fuser speed extends the image. If fuser speed is set too high, paper jams can occur.
– Decreasing fuser speed shrinks the image.
• The option can be found in Machine Status > Tools > Setup & Adjustment > Custom Paper Settings.
Select the desired Custom Paper > Change Settings > Adjust Fusing Speed > Change Settings.
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test prints and evaluate
the output to determine if additional adjustment is necessary.
TRAIL EDGE DELETIONS
PPrroobblleemm
The printed output contains trail edge deletions.
SSoolluuttiioonnss
Change the Adjust Image Transfer for Trail Edge setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR), where the image is
transferred from the belt to the paper.
• This feature can be found in Machine Status > Tools > Setup & Adjustment > Custom Paper Settings. Select
the desired Custom Paper > Change Settings > Adjust Image Transfer for Trail Edge > Change Settings.
• Decrease the Adjust Image Transfer for Trail Edge in increments of 5%–10%. After every increment
adjustment run test prints and evaluate the output to determine if additional adjustment is necessary.
Xerox
®
Versant
®
280 Press User Documentation 305
Troubleshooting

Xerox Versant 280 Specifications

General

Brand	Xerox
Model	Versant 280
Category	Power Tool
Language	English