Xerox Versant 280 User Manual

5. To permit the staple cartridge handle to open out and away from the staple refill, press in the green tabs, then
pull back the handle.
6. To remove the staple refill, press the rear of the refill container as shown.
7. Replace the staple refill, then return the staple cartridge to the booklet maker.
8. Close the front door of the Business Ready Finisher.
Emptying the Hole Punch Waste Container
A message appears on the press User Interface (UI) when the hole punch waste container is full.
WARNING: Do not perform this procedure while the printer is copying or printing.
1. Open the front door of the Business Ready Finisher.
2. Remove the hole punch waste container from its slot near the top left of the finisher.
• Wait 10 seconds before reinserting the container into the printer. The hole punch counter resets after 10
seconds.
• If you remove the hole punch waste container before the device instructs you to, empty the container
before you reinsert it into the finisher.
Xerox
®
Versant
®
280 Press User Documentation 257
Working With

Xerox Versant 280 Specifications

General

Brand	Xerox
Model	Versant 280
Category	Power Tool
Language	English