Xerox Versant 280 - Page 201

Note: If sheets are curled, changing the tray angle has no effect.
A B
Default, lower angle
Raised, upper angle
To change the angle of the tray:
1. Pull the top tray from the lower seating (A) by pulling it toward the right.
2. Insert the clutches at the lead edge of the tray into upper seating (B).
SSttaacckkeerr TTrraayy
Side stitch jobs are delivered to this tray only.
Note: Delivering 2,000 or more sheets to this tray with excessive downward curl may cause the output stack
to fall out of the tray. If this happens, set the curl correction level on the Interface Decurler Module to its
lowest level and set curl correction on the Inserter setting to downward. For information, refer to Paper Curl
Correction with the PR Finishers.
BBooookklleett TTrraayy
Note: The booklet tray is attached to PR Booklet Maker Finisher. However, if the SquareFold Trimmer is
installed, the booklet tray is attached to SquareFold Trimmer.
Bi-Fold and Bi-Fold with Saddle Stitch jobs are delivered to this tray only.
Xerox
®
Versant
®
280 Press User Documentation 201
Working With