AudioCodes E-SBC - Page 1167

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure troubleshoot
> cdr > call-end-cdr-
zero-duration-filter
[CallEndCDRZeroDurationFilter]
■ [1] Enable
'CDR Report Level'
configure troubleshoot
> cdr > cdr-report-
level
[CDRReportLevel]
Enables media and signaling-related CDRs to be sent to a
Syslog server and defines the call stage at which they are
sent.
■ [0] None = (Default) CDRs are not used.
■ [1] End Call = CDR is sent to the Syslog server at the
end of each call.
■ [2] Start & End Call = CDR report is sent to Syslog at
the start and end of each call.
■ [3] Connect & End Call = CDR report is sent to
Syslog at connection and at the end of each call.
■ [4] Start & End & Connect Call = CDR report is sent
to Syslog at the start, at connection, and at the end of
each call.
Note:
■ For the SBC application: The parameter enables only
signaling-related CDRs. To enable media-related
CDRs for SBC calls, use the [MediaCDRReportLevel]
parameter.
■ The CDR Syslog message complies with RFC 3164
and is identified by: Facility = 17 (local1) and Severity =
6 (Informational).
■ This mechanism is active only when Syslog is enabled
(i.e., the parameter [EnableSyslog] is set to [1]).
'Media CDR Report Level'
configure troubleshoot
> cdr > media-cdr-rprt-
level
[MediaCDRReportLevel]
Enables media-related CDRs of SBC calls to be sent to a
Syslog server and defines the call stage at which they are
sent.
■ [0] None = (Default) No media-related CDR is sent.
■ [1] End Media = Sends a CDR only at the end of the
call.
■ [2] Start & End Media = Sends a CDR once the
media starts. In some calls it may only be after the call
is established, but in other calls the media may start at
ringback tone. A CDR is also sent upon termination
(end) of the media in the call.
■ [3] Update & End Media = Sends a CDR when an
update occurs in the media of the call. For example, a
call starts and a ringback tone occurs, a re-INVITE is
sent for a fax call and as a result, a CDR with the
MediaReportType field set to "Update" is sent, as the
media was changed from voice to T.38. A CDR is also
sent upon termination (end) of the media in the call.
- 1129 -