CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Note: You can also configure this feature
per specific calls, using IP Profiles
(IpProfile_SBCMaxCallDuration). For a
detailed description of the parameter and for
configuring this feature in the IP Profiles
table, see Configuring IP Profiles. If this
feature is configured for a specific IP
Profile, the settings of this global parameter
is ignored for calls associated with the IP
Profile.
'SBC No Answer Timeout'
configure voip > sbc settings >
sbc-no-arelt-timeout
[SBCAlertTimeout]
Defines the timeout (in seconds) for SBC
outgoing (outbound IP routing) SIP INVITE
messages. If the called IP party does not
answer the call within this user-defined
interval, the device disconnects the
session. The device starts the timeout
count upon receipt of a SIP 180 Ringing
response from the called party. If no other
SIP response (for example, 200 OK) is
received thereafter within this timeout, the
call is released.
The valid range is 0 to 3600 seconds. the
default is 600.
configure voip > sbc settings >
num-of-subscribes
[NumOfSubscribes]
Defines the maximum number of concurrent
SIP SUBSCRIBE sessions permitted on
the device.
The valid value is any value between 0 and
the maximum supported SUBSCRIBE
sessions. When set to -1, the device uses
the default value. For more information,
contact the sales representative of your
purchased device.
Note: For the parameter to take effect, a
device reset is required.
configure voip > sbc settings >
sbc-dialog-subsc-route-mode
[SBCInDialogSubscribeRouteMode]
Enables the device to route in-dialog,
refresh SIP SUBSCRIBE requests to the
"working" (has connectivity) proxy.
■[0] = (Default) Disable – the device
sends in-dialog, refresh SUBSCRIBES
according to the address in the Contact
header of the 200 OK response received
from the proxy to which the initial
SUBSCRIBE was sent (as per the SIP
standard).
- 1337 -
To Next Page
Loading...
Need help?
General
