Version 6.6 135 October 2014
Installation & Operation Manual 21. Software Installation and Basic Configuration
4. When you are prompted if you wish to start the installation, type y and press
Enter. The software installation begins.
Start installation? (y/n) : y
Extract /sc_software.tar installation archive... done
Extract /sc_install.pl installation script... done
Install SC Software
>>> save snmp.conf in /tmp/snmp.conf.prev ...
>>> save SNMP++ stack configuration in /tmp/snmp.prev ...
(This sequence is abbreviated)
5. After the installation successfully completes the extraction of all software binary
components, you will be prompted to perform the basic configuration of the SC
software.
Software is successfully extracted.
SC board must be configured to complete the installation.
Choose one of the following configuration options:
a) "configure now" - you will be prompted to perform a new SC
configuration
b) "copy configuration" - an existing SC configuration will be copied
from another SC board
If you install the Media Gateway software on a failed SC board, choose
the "copy configuration" option to copy an existing configuration from
another SC board (currently up and running).
If you install the Media Gateway software on both SC boards, do the
following:
a) for the SC board in slot 1, choose the "configure now" option
b) for the SC board in slot 2, choose the "copy configuration" option
How do you want to configure this SC board? (1=configure now/2=copy
configuration) [1]: 1
6. Since you are installing software on the SC board to operate as the Active board,
type 1 and press Enter to select “configure now” option.
To Next Page
Loading...
