Installation & Operation Manual 136 Document # LTRT-92224
Mediant 8000
System Configuration
Keyboard shortcuts:
ENTER - leave the default parameter value as is
\ - return to the previous parameter
Ctrl-C - abort the configuration script
7. At the Global SC IP Address prompt, type the IP address to be assigned to the
Active SC board and used to connect to the Media Gateway’s management
interface (e.g., from EMS server).
Global SC IP Address [0.0.0.0]: 10.7.13.90
8. At the 1
st
SC IP Address prompt, enter the internal IP address of the SC board in
Slot 1.
1
st
SC IP Address [0.0.0.0]: 10.7.13.91
9. At the 2
nd
SC IP Address prompt, enter the internal IP address of the SC board
in Slot 2.
2
nd
SC IP Address [0.0.0.0]: 10.7.13.92
Note: Parameters 1
st
SC IP Address and 2
nd
SC IP Address are used to identify
SC boards in Slot 1 and 2 correspondingly and not to change their existing network
configuration. Software installation will fail if these parameters do not match the IP
addresses currently configured on both SC boards. If you wish to change the private
IP address of an SC board, see 'Configuring the Basic IP Network Parameters of SC
Boards' on page 117
10. At the Time Zone prompt, enter the local time zone where the Media Gateway
resides.
The time zone may be specified as an offset from the Greenwich Mean Time
(GMT) (e.g. GMT-2 or GMT+3) or as a name of a geographical area where the
Media Gateway resides (e.g. Europe/Paris or America/Denver). In the latter
case, Daylight Saving Time will be activated if the specific time zone supports it.
Time Zone [GMT]: Europe/Paris
The name of the time zone uses standard UNIX tz/zoneinfo format.
Geographical Locations are identified by continent or ocean and then by the
name of the location, which is typically the largest city within the region. For
example, America/New_York represents most of the US eastern time zone and
America/Phoenix represents most of Arizona, which uses mountain time without
daylight saving time (DST).
To Next Page
Loading...
