Installation & Operation Manual 142 Document # LTRT-92224
Mediant 8000
Note:
If you make a mistake and choose option 1 “configure now” for SC board to
operate as the Standby board, do one of the following:
• Abort installation via Ctrl-C and re-start it from the beginning (this is the preferred
option)
• Continue installation as described in 'Installing Mediant 8000 Software on the SC
Board to Operate as the Active Board' on page 134 and provide exactly the
same values that are currently configured on the Active SC board. This option is
more prone to user syntax errors (due to possible mismatches in parameter
values), however so long as the configuration information of the two SC boards
fully match, it will produce a fully functional software configuration on both Active
and Standby SC boards.
7. You will be prompted to enter the IP address of the Active SC board (or the board
to operate as the Active board, if you install software on both SC boards). Enter
the corresponding IP address and press Enter.
Active SC IP Address [10.7.13.91]: 10.7.13.91
Verify that Active SC 10.7.13.91 responds to ping...
10.7.13.91 is alive
Configuration will be copied from Active SC 10.7.13.91 via SSH.
8. At the CLI user name prompt, enter the name of a regular CLI user on the Active
SC board (e.g. acladmin). See 'Command Line Interface Users' on page 113 for
more details.
Please provide CLI user credentials:
CLI user name [acladmin]: acladmin
9. At the CLI user password prompt, enter the password of the specific CLI user
on the Active SC board (e.g. pass_12345).
CLI user password: ******
10. At the ROOT user password prompt, enter the password of root user on the
Active SC board (e.g. root).
ROOT user password: ******
Note: If you changed root password as part of Active SC software installation,
ensure that you enter the new root password at this prompt.
To Next Page
Loading...
