Installation & Operation Manual 144 Document # LTRT-92224
Mediant 8000
>>> Install OS patches ...
SC software contains new OS patches that must be installed.
Installation of OS patches may take considerable time.
However without these OS patches SC software may not function
properly and/or SC security may be compromised.
Install OS patches? (y/n) [y]: y
Applying 112785-65 (1 of 25) ... done
Applying 112837-16 (2 of 25) ...
(This sequence is abbreviated)
Note: Installation of the OS patches may take a considerable amount of time – up
to 1.5 hours. The exact amount of time depends on which previous Mediant 8000
software version was installed on the specific SC board.
Installation of OS patches on the SC Rev.2 board (using the Linux OS) is
considerably shorter and typically takes only a few minutes.
14. After the installation successfully completes, you will be prompted to reboot the
SC board.
SC board must be rebooted to complete the installation.
After the reboot, do the following:
1) connect to the Active SC board (via Global IP address)
2) run "tools ems" script to configure connectivity
between Media Gateway and EMS server
3) if VLAN must be configured on the OAM interface,
run "tools vlan" script
REBOOT now (y/n) [y]: y
Are you sure (y/n) [y]: y
If you are installing the Mediant 8000 software on both SC boards, prior to this
installation (on the Standby SC board), you have waited for the SC board to
operate as the Active board to complete the reboot process. Reboot both SC
boards simultaneously by typing y and pressing Enter on the respective SC
board’s CLI interfaces.
15. The SC board reboots. It typically takes 2 minutes to complete the reboot
process. The Media Gateway software starts automatically after the SC board
completes the reboot.
To Next Page
Loading...
