Version 6.6 173 October 2014
Installation & Operation Manual 24. SNMP Management Interface
EMS Privacy Protocol (0-No, 1-DES) : 1
e. At the EMS Privacy Key prompt, enter the Key that will be used to ensure
privacy of SNMPv3 messages.
EMS Privacy Key [leave unchanged]: ******
9. If you have chosen the SNMPv2 or SNMPv2+IPSEC mode, you must enter the
SNMP Read Community and the SNMP Write Community parameters.
• At the SNMP Read Community prompt, enter the Read Community string
used to authorize read operations performed by the EMS server and other
SNMP managers. Press Enter to leave current SNMP Read Community
string unchanged. Default value for SNMP Read Community string is public.
SNMP Read Community [leave unchanged]: public
• At the SNMP Write Community prompt, enter the Write Community string
used to authorize write operations performed by the EMS server and other
SNMP managers. Press Enter to leave current SNMP Write Community
string unchanged. Default value for SNMP Write Community string is
private.
SNMP Write Community [leave unchanged]: private
10. If you have chosen the SNMPv2+IPSEC mode, you must configure the
IPSEC/IKE association between the Media Gateway and the EMS server.
To configure the transport mode IPSEC/IKE association between the Media
Gateway and the EMS server, enter the EMS IKE Pre-Shared Key parameter. To
configure the tunnel mode IPSEC/IKE association, press Enter and use the EMS
GUI or CLI to configure the SC IPSEC Rules table (see 'Configuring IPSEC/IKE
for Management Interfaces (on SC boards)' on page 341).
To configure IPSEC/IKE association in transport mode between
Media Gateway and EMS server, enter Preshared Key now.
Otherwise, press ENTER and use EMS GUI or CLI to configure
the SC IPSEC Rules table (moSCIPSECRule).
EMS IKE Pre-Shared Key [don't configure]: *******
To Next Page
Loading...
