Version 6.6 181 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
5. Login as a CLI user with administrative privileges (e.g. acladmin). For more
information, see Section section 'Logging into the Command Line Interface' on
page 115.
6. Type the following command to reset the IP network configuration to default:
SC-1 -- ~ -- /moGW
• modify Interfaces=0
7. If the OAM network uses VLAN tagging, type the following command to configure
the OAM VLAN Tag ID (replace 84 by actual VLAN Tag value):
SC-1 -- ~ -- /moGW
• modify OAMTagID=84
8. Type the following commands to lock both ES boards; type y to confirm the lock
maintenance action:
SC-1 -- ~ -- /moGW
• lock esboard#9
Do you really want to lock /moGW/moSwitchBoard# 9 ? [y/n] y
Performing lock action on /moGW/moSwitchBoard# 9 - OK!
• lock esboard#19
Do you really want to lock /moGW/moSwitchBoard#19? [y/n] y
Performing lock action on /moGW/moSwitchBoard#19 - OK!
9. Type the following command to unlock the ES board in slot 9:
SC-1 -- ~ -- /moGW
• unlock esboard#9
Performing unlock action on /moGW/moSwitchBoard#9 - OK!
10. Wait up to 10 minutes until the ES board in slot 9 completes the restart and
returns to service. Use the following command to determine whether the ES
board has completed the restart. Value Enabled(1) indicates that the ES board is
back in service:
SC-1 -- ~ -- /moGW
• show esboard#9 param OperationalState
OperationalState=Enabled(1)
11. Type the following command to unlock the ES board in slot 19:
SC-1 -- ~ -- /moGW
• unlock esboard#19
Performing unlock action on /moGW/moSwitchBoard#19 - OK!
To Next Page
Loading...
