AudioCodes Mediant 8000 - Page 593

Version 6.6 593 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter
Name
Type
Provisioning
Type
Description
Trunk RTP Only
Mode
Enum
Disable,Transmit,
Receive,Transmit
Instant Enables the device to start sending and/or
receiving RTP packets to and from remote
endpoints without the need to establish a
SIP session. This is configured per trunk.
The remote IP address is determined
according to the 'Outbound IP Routing' table.
The port is the same port as the local RTP
port (configured by the parameter
BaseUDPPort (see page 600) and the
channel on which the call is received).
 [0] Disable
 [1] Transmit & Receive = send and
receive RTP packets
 [2] Transmit = send RTP packets only
RTCP XR
Collection
Server
Enum
Disable, Enable
Instant Determines the transport layer used for
outgoing SIP dialogs initiated by the device
to the RTCP XR Collection Server.
Send Screening
Indicator to IP
Enum
Not Overwrited(-
1), User
Provided(0), User
Passed(1), User
Failed(2), Network
Provided(3)
Instant Defines how the screening indicator of the
calling party's number (CPN) is generated
for Tel-to-IP calls.
 Not Overwrited – not configured
(interworking from ISDN to IP) or set to 0
for CAS.
 User Provided – CPN set by user, but not
screened (verified).
 User Passed – CPN set by user, verified
and passed.
 User Failed – CPN set by user, verified
and failed.
Network Provided – CPN set by network.
Note: This parameter is applicable only if the
Remote Party ID (RPID) header is enabled.