AudioCodes Mediant 8000 - Page 619

Version 6.6 619 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter Name Type Provisioning Type Description
Inbound
Message
Manipulation Set
Integer
-1 – 19
Instant Message Manipulation Set (rule)
that you want to assign to this IP
Group for SIP message
manipulation rule on the inbound
message.
Outbound
Message
Manipulation Set
Integer
-1 – 19
Instant Message Manipulation Set (rule)
that you want to assign to this IP
Group for SIP message
manipulation on the outbound
message.
Source URI Enum
NotConfigured,Fro
m,To,RequestURI,
PAssertedFirstHe
ader,PAssertedSe
condHeader,PPref
erred,Route,Diver
sion,HistoryInfo,P
AssociatedURI,PC
alledPartyID,Cont
act
Instant The source URI input used in the
(CMR) Classify-Manipulate-Route
process in SBC.
Defining source URI:
 Request
 If REGISTER request –
use the TO header as the
source URI
 For all other requests,
perform the following
steps:
 -Use P-Preferred header if
exist. If not, go to step 2.
 -Use the first header in
the P-Asserted headers
list, if exist. If not, go to
step 3.
 -Use FROM header as
source URI.

Response
 Use the TO header as the
source URI
Destination URI Enum
NotConfigured,Fro
m,To,RequestURI,
PAssertedFirstHe
ader,PAssertedSe
condHeader,PPref
erred,Route,Diver
sion,HistoryInfo,P
AssociatedURI,PC
alledPartyID,Cont
act
Instant The destination URI inputused in
the (CMR) Classify-Manipulate-
Route process in SBC.
Defining destination URI:
 Use Request-URI header as the
destination URI (applies for all
message types)