EasyManua.ls Logo

AudioCodes Mediant 8000 - Page 698

AudioCodes Mediant 8000
924 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation & Operation Manual 698 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type Provisioning
Type
Description
Play RB
Tone to IP
Enum
Disable, Enable
Instant Enables/disables play
ofringback tone to the IP side of
the call after SIP 183 session
progress response is sent.
If enabled and
EnableEarlyMedia=1, for IP-to-
Tel calls the gateway may play
a ringback tone to IP, according
to the following:
For CAS interfaces, the gateway
opens a voice channel, sends a
183+SDP response and plays a
Ringback tone to IP.
For ISDN interfaces, if a
Progress or an Alert message
with PI (1 or 8) is received from
the ISDN, the gateway opens a
voice channel, sends a
183+SDP or 180+SDP
response, but it doesn’t play a
Ringback tone to IP. If PI (1 or
8) is received from the ISDN,
the gateway assumes that
Ringback tone is played by the
ISDN Switch. Otherwise, the
fateway plays a Ringback tone
to IP after receiving an Alert
message from the ISDN. It
sends a 180+SDP response,
signaling to the originating party
to open a voice channel to hear
the played Ringback tone.
Notes:
To enable the gateway to
send a 183/180+SDP
responses, set
EnableEarlyMedia to 1.
If EnableDigitDelivery = 1,
the gateway doesn’t play a
Ringback tone to IP and
doesn’t send 183 or
180+SDP responses.

Table of Contents

Related product manuals