Installation & Operation Manual 750 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type
Provisioning
Type
Description
Destination IP
Group
Integer
0-32
Instant Defines the index of the IP Group to
where the outbound IP-to-IP call will be
routed. The INVITE messages are sent
to the IP address(es) defined for the
Proxy Set associated with this IP Group.
If you select an IP Group, it is
unnecessary to configure a destination
IP address (in the 'Destination Address'
field). However, if both parameters are
configured, the INVITE message is sent
only to the IP Group.
If the destination IP Group is of USER
type, the device searches for a match
between the requested URI (of the
received INVITE) to an AOR registration
record in the device's internal database.
The INVITE is then sent to the IP
address of the registered contact.
Note: This is only relevant if parameter
'Destination Type' is set to IP Group.
However, regardless of the settings of
the parameter 'Destination Type', the IP
Group is still used - only for determining
the IP Profile or outgoing SRD. If neither
IP Group nor SRD are defined in this
table, the destination SRD is determined
according to the source SRD associated
with the Source IP Group (configured in
the 'IP Group' table). If this table does
not define an IP Group; however only an
SRD, then the first IP Group associated
with this SRD (in the 'IP Group' table) is
used.
Destination
SRD
Integer
-1 – 32
Instant Determines the SRD.
Note: The destination IP Group must
belong to the destination SRD if both are
configured.
To Next Page
Loading...
