FW-DWNLD (Firmware Download)
Issue 4 May 2002
10-859555-233-123
2. Type list directory board <UUCSS> and press Enter.
The List Directory screen (Screen 10-5) appears.
3. Verify that the new firmware image file is not listed in the
File/Directory Name field.
4. Type disable filesystem board <UUCSS> and press
Enter to disable the
filesystem on the source circuit pack.
NOTE:
This command is only successful if no files remain on the source
circuit pack.
Troubleshooting firmware downloads
This section contains three troubleshooting sections:
■ ‘‘Reset 1 or 2’’
■ ‘‘Test firmware download’’
■ ‘‘Backing out of a firmware download’’
Reset 1 or 2
If the system does a reset 1 or 2 and no alarms are present:
1. At the SAT type display initcauses and press
RETURN.
2. Clear any errors.
3. Perform the procedures in the ‘‘Error Log Entries and Test to Clear Values’’
section.
Test firmware download
To test the firmware download process:
1. At the SAT type test firmware download and press
RETURN.
The Test Results screen (Screen 10-13) appears.
Screen 10-13. Test Results screen
test firmware download SPE A
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
FW-DWNLD 1413 PASS
To Next Page
Loading...
