Maintenance Object Repair Procedures
555-233-123
10-862 Issue 4 May 2002
6. At the SAT type get boot-image <UUCSS> and press RETURN to check the
status of the firmware images on the target circuit pack.
The Display Firmware Image(s) report (Screen 10-16) appears.
Screen 10-16. Display Firmware Image(s) screen
7. Ensure that both the Active Image and the Reset Image fields are as
you expect.
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 257 — a log only error indicating that a certain software
resource was not available. Such an error very seldom occurs and usually
produces a proc_err. However, in the firmware download feature, the file
cannot be downloaded and/or the schedule can also abort/fail. To resolve
the error, use the test firmware download command. The Aux Data
specifies the error that resulted from the resource not being available. See
Table 10-308 for more details.
Table 10-307. FW-DWNLD Maintenance Error Log Entries
Error
Type
Aux
Data Cause Of Error
Alarm
Level
On/
Off
Board Test to Clear Value
257(a) See note Download failure MINOR OFF test firmware download UUCSS
258(b) See note Download failure MINOR OFF test firmware download UUCSS
259(c) See note Download failure MINOR OFF test firmware download UUCSS
513(d) See note Download failure MINOR OFF test firmware download UUCSS
796(e) See note Firmware
download request
MINOR OFF test firmware download UUCSS
get boot-image 1C07
DISPLAY FIRMWARE IMAGE(S)
Image 1 Image 2
Board Type: TN2501 TN2501
FW Vintage: 02 01
HW Signature: 02 02
Suffix: A A
Date: 03/02/02 03/02/01
Timestamp: 10:30:50 12:42:18
CRC Checksum: Good Good
Active Image: No Yes
Reboot Image: No Yes
To Next Page
Loading...
