FW-DWNLD (Firmware Download)
Issue 4 May 2002
10-863555-233-123
b. Error Type 258 — a log only error indicating that a source board related
error occurred. The download schedule can also abort/fail. To resolve the
error, use the command test firmware download. The Aux Data specifies
the error. See Table 10-309 for more details.
Table 10-308. Error Type 257 Aux Data
Aux
Data Description of Failure
1 Source board query failed - Check for system wide problems, clear all errors
and retry the download.
2 Target board query failed - Check for system wide problems, clear all errors
and retry the download.
3 Allocating resources failed - Check for system wide problems, clear all errors
and retry the download.
4 Firmware Download Information table query failed - Check for system wide
problems, clear all errors and retry the download.
5 Header message failed - Check for system wide problems, clear all errors and
retry the download.
6 Download Map timer expired - Check for system wide problems, clear all
errors and retry the download.
Continued on next page
Table 10-309. Error Type 258 Aux Data
Aux
Data Description of Failure
1 Download image file specified on the change firmware download screen not
present on the source board, use the list dir command to verify file system
contents.
2 The image on the source board has an invalid header, retry then escalate.
3 Bad CRC on image file on source board, retry then escalate.
4 File name too long, rename then try again.
5 Invalid TN code on the change firmware download screen does not match
TN code of image on the source board. Verify screen, make sure the correct
image is being used.
6 Invalid suffix on the change firmware download screen does not match suffix
of image on the source board. Verify screen, make sure the correct image is
being used.
Continued on next page
To Next Page
Loading...
