Maintenance Object Repair Procedures
555-233-123
10-864 Issue 4 May 2002
c. Error Type 259 — a log only error indicating that the target board failed to
download. To resolve the error, use the command test firmware
download. The Aux Data specifies the error. See Table 10-310 for more
details.
7 Source board not present, verify entry on the change firmware download
screen, and translations.
8 Incorrect source board, verify that the source board is the correct TN code.
9 PPP ports not available, use another source board or reschedule the download
for off hours.
10 DL Setup message to source failed. Retry download and if download still fails
escalate.
Table 10-310. Error Type 259 Aux Data
Aux
Data Description of Failure
1 Target board not present / not responding, check board location, translations
and retry.
2 Incorrect target board for download schedule, verify board location, and
schedule.
3 Target failed to go into DL Mode, retry
4 Target received bad file header
5 Bad image checksum on image on source board, get new image retry.
6 TFTP protocol error - One reason for this type of failure could be that the
target board has ami-zcs line coding, and is located in a EPN with ami-zcs line
coding between the source and target board. To have a successful firmware
download you must have a clear channel between the source and target
board. Some examples of the correct type of line coding for this feature are:
b8zs, and hdb3.
7 File transfer timer expired, check board location, translations and retry.
8 Target failed to reset after transfer, check board location, translations and
retry.
9 Download of target failed, check location, translations, and retry.
Continued on next page
Table 10-309. Error Type 258 Aux Data — Continued
Aux
Data Description of Failure
Continued on next page
To Next Page
Loading...
