FW-DWNLD (Firmware Download)
Issue 4 May 2002
10-861555-233-123
4. At the SAT type get boot-image <UUCSS> and press RETURN to check the
status of the firmware images on the target circuit pack.
The Display Firmware Image(s) report (Screen 10-15) appears.
Screen 10-15. Display Firmware Image(s) screen
Note that the values in both the Active Image and the Reset Image
fields have changed.
5. Reseat the circuit pack to activate the new firmware image:
!
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a
grounding strap while handling the circuit pack.
!
CAUTION:
For TN2501AP (VAL) ensure that both the top green and top amber
LEDs are out.
a. Release the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack out approximately 1-2 inches (2.54 to 5.08 cm.).
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Wait until all 3 of the top LEDs (red, green, and amber) are out.
get boot-image 1C07
DISPLAY FIRMWARE IMAGE(S)
Image 1 Image 2
Board Type: TN2501 TN2501
FW Vintage: 02 01
HW Signature: 02 02
Suffix: A A
Date: 03/02/02 03/02/01
Timestamp: 10:30:50 12:42:18
CRC Checksum: Good Good
Active Image: Yes No
Reboot Image: No Yes
To Next Page
Loading...
