ISDN-TRK (DS1 ISDN Trunk)
Issue 4 May 2002
10-999555-233-123
Asynchronous Commands
You can start, query, and stop an outgoing test call by using the following
maintenance commands:
■ test isdn-testcall trunk-group-no/member-no [ minutes ]
This command enables you to start an outgoing ISDN-PRI test call for a
maximum of two hours (120 minutes).
■ status isdn-testcall trunk-group-no/member-no
This command displays the progress of the outgoing test call by reporting
the bit and block error rates of the tested B-channel specified by the “trunk
group no/member no” identifier.
■ clear isdn-testcall trunk-group-no/member-no
This command enables you to stop an outgoing test call already in
progress. The trunk-group-no/member-no identifier specifies the
B-channel used to stop the test call. The measurements are not cleared
until the next test call begins.
NOTE:
Only one trunk can be tested in a given port network, until the test call is
canceled or completes.
Table 10-363. TEST #258 ISDN TEST Call
Error
Code
Te s t
Result Description/Recommendation
4 ABORT There is a problem with the Processor Interface Link.
1. Refer to PI-LINK (Processor Interface Link).
8 ABORT There is a problem with the DS1 interface circuit pack.
1. Refer to DS1-BD (DS1 Interface Circuit Pack).
1004 ABORT B channel in use.
1. Determine if a call is active on this DS1 ISDN Trunk via
status trunk.
2. When the service state indicates in-service/idle, retry the
test.
1005 ABORT Bad Configuration (that is, no Maintenance/Test circuit pack)
Issue test trunk <trunk Group/trunk member> and make
sure there is a DATA-CHL (NETCON channel) administered.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
Continued on next page
To Next Page
Loading...
