LIC-ERR (License-Error Mode)
Issue 4 May 2002
10-1011555-233-123
Log in warning messages
If the system is in either License-Error or No-License modes, anyone logging on
to the System Access Terminal (SAT) receives a warning message, depending on
the conditions.
■ When “License Error: Serial Number Mismatch” (or some other description)
appears, the system is telling you that
— The switch is in License-Error mode.
— The system detected a license file serial number mismatch between
the License File and the actual hardware in the switch.
■ When “Call Processing Will Be Blocked in Approximately xxx hours”
appears, the system is telling you that
— The switch is in License-Error Mode.
— The 6-day countdown timer has started and you have xxx hours
before you enter No-License mode.
■ When “Call Processing Blocked” appears, the system is telling you that
— The switch is in No-License Mode.
— The switch allows only incoming and outgoing calls to
pre-administered numbers.
License modes
Table 10-365 shows the 3 license modes, descriptions, and repair procedures.
Table 10-365. Error messages and repair procedures
License
Mode Description Explanation and repair procedure
License-
Normal
No mismatches
between license and
switch; stable running
condition
None needed
Continued on next page
To Next Page
Loading...
