Maintenance Object Repair Procedures
555-233-123
10-1180 Issue 4 May 2002
2000 ABORT The test was aborted because response to the test was not
received within the allowable time period.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
2. If the test aborts with error code 2000 again, run short test
sequence on the associated DS1-BD or UDS1-BD. If tests
138 through 145 on the associated DS1-BD or UDS1-BD are
also aborting with error code 2000, hyperactivity on the
board or facility is indicated. In this case, the hyperactivity
problem should be dealt with first.
3. If the test continues to abort and the board is OK, escalate
the problem.
2012 ABORT The test was aborted due to a system error.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
Table 10-444. TEST #312 DS1OPS Switchhook Inquiry Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
