ATM Tips
Issue 4 May 2002
5-93555-233-123
Screen 5-32 shows the screen output for display errors.
Screen 5-32. Screen output for display errors command
In this example the errors that have ATM-NTWK for Name and 1 for Data
indicate an error returned to the TN230X from the ATM network. In this
case, Type indicates the Cause Code returned by the ATM network (see
Table 5-10 below). In the example above, two Cause Codes (41 and 3) are
reported from the ATM network. For more information about these Cause
Codes and repair information see ‘‘ATM-SGRP (ATM Signaling Group)’’.
Table 5-10. Observed Cause Codes
Cause
Code Definition Observed Cause
3 No route to destination The ATM addresses administered in the ATM switch (show
signaling routes or show signaling esi) or in DEFINITY
(display atm pnc) are incorrect.
31 Normal, unspecified This is a normal return.
41 Temporary failure This “try again later” Cause Code has been observed when
the source of the problem is on another port (for example, a
routing problem on another port that displays Cause Code 3).
47 Resources unavailable,
unspecified
DEFINITY call volume is too high for the available resources
in the ATM network.
63 Service or option
unavailable, unspecified
DEFINITY call volume is too high for the available resources
in the ATM network.
display errors Page 9 SPE A
HARDWARE ERROR REPORT
Port Mtce Alt Err Aux First Last Err Err Rt/ Al Ac
Name Name Type Data Occur Occur Cnt Rt Hr St
AT01A ATM-NTWK 41 1 11/12/16:59 12/09/15:10 14 0 0 n n
AT01A ATM-NTWK 31 0 11/13/18:27 11/20/20:02 5 0 0 n n
AT02A ATM-NTWK 0 0 11/13/18:45 11/13/18:45 1 0 0 n n
AT02A ATM-NTWK 31 0 11/15/14:40 11/15/14:41 2 120 0 n n
AT01B ATM-NTWK 31 0 11/16/17:39 11/16/17:39 1 0 0 n n
AT01A ATM-NTWK 3 1 11/16/18:19 11/26/13:13 12 0 0 n n
To Next Page
Loading...
