PPP-PT (Control LAN Packet/Port)
Issue 4 May 2002
10-1359555-233-123
TCP/IP Ping Test (#1281)
This non-destructive test fails if the endpoint fails to respond. Use this test to
check the circuitry in the data path for a peer-to-peer IP layer connection.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
FAIL CLAN circuit pack detected test failure.
1. If the problem persists, reset the circuit pack (busyout board
UUCSS, reset board UUCSS, and release board UUCSS).
2. If the problem persists, replace the circuit pack.
PASS Port circuitry functioning properly.
Table 10-501. TEST #1275 SCOTCH Synchronous Looparound Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
