Maintenance Object Repair Procedures
555-233-123
10-1378 Issue 4 May 2002
MTP Sanity Handshake Test (#106)
This test is a nondestructive test. The MTP Sanity Handshake Test is simply a
query from a maintenance process to the MTP. The MTP must reply for the test to
pass.
Table 10-510. TEST #106 MTP Sanity Handshake Test
Error Code
Tes t
Result Description/Recommendation
100 ABORT The test did not complete within the allowable time period.
1. Retry the command.
1000 ABORT System software resources required for this test are not
available.
1. Retry at 1-minute intervals a maximum of 5 times.
1029 2014
2015 2016
2017 2018
2020 2022
2024 2025
2051
ABORT Refer to “STBY-SPE” for a description of these error
codes.
2000 ABORT The response to the test request was not received within
the allowable time period.
2033 ABORT Internal system error.
1. Repeat the command at 1-minute intervals a
maximum of 5 times.
FAIL The MTP did not respond to the Sanity Handshake Query.
1. Re-enter command with the “long” option.
2. If the test continues to fail, replace the Processor
circuit pack.
NOTE:
If you replace the Processor circuit pack, you
need to obtain a new license file.
PASS The MTP responded to the Sanity Handshake Query.
Continued on next page
To Next Page
Loading...
