PRI-CDR/SEC-CDR (PRI-CDR Link)
Issue 4 May 2002
10-1415555-233-123
Link Retry Test (#215)
This test sends a message to the CDR software process to make a data call to the
extension where the CDR output device connects to or opens the EIA port to the
CDR output device. If the CDR link is already up, this test is passed without
making any data call or opening the EIA port.
Table 10-530. TEST #215 Link Retry Test
Error
Code
Te s t
Result Description/Recommendation
10 ABORT Internal system error
20 ABORT Internal system error. Internal error in Maintenance Action
Process (MAP). MAP returns an error back to maintenance script
(HMM). Timer expires while waiting for the reply from MAP.
1. Retry the command at 1-minute intervals a maximum of 5
times.
30 ABORT Internal system error
1. Refer to ‘‘Procedures for Restoring the CDR Link’’.
1010 ABORT The CDR link has been busied out to out-of-service.
1. Enter release cdr-link primary|secondary command to
release the CDR link from busyout state.
2. Retry test cdr-link primary|secondary long command to
execute the test.
FAIL The CDR link CANNOT be established.
1. Refer to the ‘‘Procedures for Restoring the CDR Link’’ for
instructions.
PASS The CDR link is up.
Continued on next page
To Next Page
Loading...
