Maintenance Object Repair Procedures
555-233-123
10-1436 Issue 4 May 2002
1018 ABORT The test has been disabled via administration. The default for
the
Test field on the Station form is y.
1. Determine why this field has been set to n on this
station (this may be due to the ringing application
test 48, which can be customer or terminal
disturbing).
2. To enable the test for the particular analog station
being tested, enter change station extension and
set the Test? field on the Station form to y.
1392 ABORT This port is currently a TTI port and the test will not execute on
it.
1. Verify that the port is a TTI port using either the
display port command (the display shows that the
port is a TTI port) or the list config command (the
display shows a t for the port).
2. If the port is not a TTI port, escalate the problem. If
both commands indicate that the port is a TTI port,
the abort is correct for the test, and no action is
necessary.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a
maximum of 5 times.
Table 10-544. TEST #35 Battery Feed Test — Continued
Error
Code
Te st
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
