TAPE-DAT (Tape Consistency)
Issue 4 May 2002
10-1647 555-233-123
36 FAIL The update files and load vintages are different in both SPEs.
The Active SPE has the most current update file.
37 FAIL The update files, load vintages, and translations are different
in both SPEs. The Active SPE has the most current update file
and translations.
38 FAIL The update files, load vintages, and translations are different
in both SPEs. The Active SPE has the most current update
file, and the Standby SPE had the most current translations.
1. Follow the procedures for Error Code 4 to get the correct
load vintage. After running the test tape long command,
check for Error Code #32 or #64. Follow the recovery
procedure under the applicable error code.
40 FAIL The update files and announcements are different in both
SPEs. The Active SPE has the most current update file and
announcements.
1. Issue the save announcements command to save
announcements on both SPEs.
2. Have INADS issue the copy update-file command to
copy the update file from the Active to the Standby SPE.
3. Issue test tape long again to resolve the alarms.
41 FAIL The update files, translations, and announcements are
different in both SPEs. The Active SPE has the most current
update file, translations, and announcements.
42 FAIL The update files, translations, and announcements are
different in both SPEs. The Active SPE has the most current
update file and announcements, and the Standby SPE has
the most current translations.
1. Issue the save translations command.
2. Issue the save announcements command.
3. Have INADS issue copy update-file to copy the update
file from the Active to the Standby SPE.
4. Reissue test tape long to resolve the alarms.
Table 10-607. TEST #421 Tape Data Consistency Check Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
