Maintenance Object Repair Procedures
555-233-123
10-1778 Issue 4 May 2002
1900 ABORT The test completion message was not received from the
TN771 circuit pack.
1. Test the TN771 circuit packs.
1901 ABORT This error occurs when the TN771 circuit pack uplinks a
message that is not the proper response for this test. The
anticipated uplink messages are seize, ring or answer.
1. Verify that the Trunk is administered properly.
1905 ABORT Intercept tone detected from far end.
1. Get the test line data from the and verify it with the far
end. Dial the test number manually to see if the TTL is
reached. If it is not, then either the number is wrong, or
the far end is administered incorrectly.
1906 ABORT Reorder tone detected from far end.
1. See actions for error code 1905.
1907 ABORT Other unexpected tone detected from far end.
1. See actions for error code 1905.
1913 ABORT Audible Ring detected from far end.
1. See actions for error code 1905.
1914 ABORT Unidentified interrupted tone detected from far end.
1. See actions for error code 1905
1915 ABORT Busy tone detected from far end.
1. Since the test line at the far end was busy. Try the test
again.
2. If the test continues to abort, the problem is with the far
end system.
1918 ABORT Test progress tone not removed from far end (type 105 test
line only).
1. The problem is with the far end system; a technician at
the far end should test the test line (TN771 or ADFTC).
1919 ABORT Unexpected far end release
1. The problem is with the far end system; a technician at
the far end should test the test line (TN771 or ADFTC).
1920 ABORT No response from far end.
1. The problem is with the far end system; a technician at
the far end should test the test line (TN771 or ADFTC).
Table 10-652. TEST #844-848 Transmission Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
