test trunk
Issue 4 May 2002
A-149 555-233-123
test trunk
Help Messages
If the system technician presses HELP after entering “test trunk” the following
message appears:
Enter group # or group #/member #, [’long’ or ’short’],
[’repeat’ (1-100) or ’clear’], [’schedule’]
Error Messages
If the format for the trunk location is incorrect, the following error message would
be displayed:
Format invalid
If the trunk group or member range is invalid, the following message appears:
Trunk or trunk group invalid
If a software fault is encountered while the command is executing, the following
message appears:
Error encountered, can’t complete request
If the trunk group is not administered, the following message appears:
Group not assigned, or group assigned but with no member
If the trunk group member is not administered, the following message appears:
Group member not assigned
If there are no tests found for this maintenance object, the following message
appears:
No tests for this MO
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
