Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-314 Issue 4 May 2002
ASAI 0-63 Established blank blank Transitory state for ASAI adjuncts.
ASAI signaling is connects at Layer
2. Layer 3 Restart procedure does
not complete between switch and
adjunct.
1. Check the adjunct by following
the manufacturer’s
recommended repair
procedures.
2. Verify repairs by executing the
status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 0-126 Established ext blank Normal state for non-MIM
initializing, fixed and automatic
TEIBRI endpoints.
BRI,
ASAI
64-
126
Established blank blank Transitory state for automatic
TEIBRI endpoints which support
MIM initialization.
1. Verify that SPID administration
on the switch and endpoint are
consistent. Verify the repair by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the signaling
link is L3-Established.
Otherwise, proceed to Step 2.
2. Try to replace the endpoint.
Verify the repair by executing
the status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 64-
126
L3-
Established
ext blank Normal state for automatic TEIBRI
endpoints supporting MIM
initialization.
Table 8-10. Status BRI-Port Command Interpretation — Continued
Endpoint
Types
TEI
Range Layer 2 State
Voi c e
Extension
Service
SPID Description /Recommendation
Continued on next page
To Next Page
Loading...
