Maintenance Object Repair Procedures
555-233-123
10-124 Issue 4 May 2002
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
1 FAIL The switchhook audit failed. This result does not indicate a
hardware problem. The other updates were not performed
because of this failure. This may occur if the audit is
performed at the same time the terminal equipment goes
off-hook.
1. Use the status station extension command to
determine when the port is available.
2. Retry the command at 1-minute intervals no more than 5
times.
3. If the test continues to fail, escalate the problem.
5 FAIL The message waiting lamp update failed. This may be an
internal software error. The translation and ringer updates
were not performed because of this failure.
7 FAIL The translation update failed. There may be an internal
software error. The ringer update was not performed because
of this failure.
Table 10-41. Test #36 Station Status and Translation Audits and Updates
— Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
