Datalogic Magellan 9800i - Sleep Mode Timer

004C30(CR)
Enter/Exit Programming Mode
116 Magellan™ 9800i Scanner
Sleep Mode Timer
This feature specifies the amount of time of inactivity (with no label reads) before the scanner
enters sleep mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set Sleep Mode Timer below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the Keypad in Appendix C that represent the desired
time interval. The selectable range is 000-255 in 15 second incr
ements. Pad all numbers
with leading zeros to yield a three-digit entry (000-255).
4. Scan the Enter/Exit Programming Mode bar code to exit Programming Mode.
03AF(CR)
Set Sleep Mode Timer
DEFAULT
Default setting for this feature is: 5 minutes
Label Gone Timeout = 1.2 Seconds
004C40(CR)
Label Gone Timeout = 1.6 Seconds