Datalogic Magellan 9800i User Manual

Enter/Exit Programming Mode
Product Reference Guide 225
Global Suffix
This feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, and Single Cable). It
specifies the suffix that is added to end of a label transmission. Three standard options are
available below. Contact your dealer for other alternate settings for this feature.
• No Global Suffix
• CR — Carriage Return
• CR LF — Carriage Return, Line Feed
To set the Global Suffix:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
031E00(CR)
Global Suffix = No Global Suffix
031E0D00(CR)
Global Suffix = CR
DEFAULT
031E0D0A00(CR)
Global Suffix = CR LF

Datalogic Magellan 9800i Specifications

General

Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Power consumption (typical)	12 W
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Built-in display	No

Weight and Dimensions

Weight	- g